

Different Material Names for C26000 Brass Pipe/ Tube: GB- H68, ISO- CuZn32, ASTM- C26000, JIS- C2600, BS--, DIN- CuZn33.

| Brass Tube: Comprehensive Details | |||
| Common Brass Alloy Grades for Tube Form | |||
| UNS Number | Common Name | Nominal Composition (Cu/Zn) | Key Characteristics |
| C22000 | Commercial Bronze (90/10) | 90% Cu / 10% Zn | Good corrosion resistance, excellent cold working properties |
| C23000 | Red Brass (85/15) | 85% Cu / 15% Zn | Good strength, corrosion resistance |
| C26000 | Cartridge Brass (70/30) | 70% Cu / 30% Zn | Exceptional cold workability, high strength-to-ductility ratio |
| C27000 | Yellow Brass (65/35) | 65% Cu / 35% Zn | Good balance of strength and ductility |
| C27200 | Yellow Brass (63/37) | 63% Cu / 37% Zn | Similar to C27000 |
| C27400 | Yellow Brass (62.5/37.5) | 62.5% Cu / 37.5% Zn | Good general purpose |
| C28000 | Muntz Metal (60/40) | 60% Cu / 40% Zn | Higher strength, good hot working |
| C33000 | Leaded Brass | 66% Cu / 33.5% Zn / 0.5% Pb | Improved machinability |
| C33200 | High-Leaded Brass | 66% Cu / 32.4% Zn / 1.6% Pb | Superior machinability |
| C37000 | Leaded Brass | 60% Cu / 39% Zn / 1.0% Pb | Good machinability |
| C44300 | Admiralty Brass | 71.5% Cu / 27.5% Zn / 1.0% Sn | Excellent corrosion resistance, especially in seawate |
| ASTM B135/B135M – Temper Designations | |||
| Temper Code | Designation | Description | Typical Application |
| H55 | Light-Drawn (Bending) | Some stiffness but capable of being bent | Bending applications |
| H58 | Drawn | General purposes, most commonly used | No specific requirement for high strength or bending |
| H80 | Hard-Drawn | As strong as commercially feasible for sizes indicated | High strength requirements |
| O50 | Light Anneal | Annealed temper | General purposes |
| O60 | Soft Anneal | Fully annealed | Maximum formability |
| Comparison: Seamless Brass Tube vs. Welded Brass Tube | |||
| Attribute | Seamless Brass Tube | Welded Brass Tube | |
| Standard | ASTM B135/B135M | ASTM B587 -3 | |
| Manufacturing | Cold drawn, annealed, redrawn | Forged or fusion welded, finished by various methods | |
| Pressure Integrity | Superior | Good (Type dependent) | |
| Cost | Higher | Lower | |
| Applications | High-pressure, critical applications | General engineering applications | |
| Types | Round, rectangular, square | Round, rectangular, square | |
| Tempers | H55, H58, H80, O50, O60 | Type I, II, III, IV | |


